- EUROTHERM ITOOLS NOT FINDING DEVICE DRIVERS
- EUROTHERM ITOOLS NOT FINDING DEVICE DRIVER
- EUROTHERM ITOOLS NOT FINDING DEVICE SOFTWARE
Navigate to the file that you previously saved, and click “Load”.
Once you finish scanning and synchronizing, Click the “Load” button at the top toolbar. It is important to note that both controllers must have the same exact hardware model code. Once iTools finishes removing the controller, you can disconnect it from the clip, and connect the new controller in the same way you connected the first. When finished, click “Remove” to safely disconnect the controller. You now have a clone file with all the configuration settings of the controller. Navigate to an appropriate directory on your computer where you would like to store the file, give it an appropriate name, ensure that the “Save as type” is. In order to clone the controller, go to the toolbar at the top and press the “Save” icon. If you did not select “Terminate scan when first device is found” you will want to now press scan again to stop further scans.Īllow the controller to finish synchronizing before proceeding. When an instrument is detected, a screen view similar to the one shown will be displayed. You can also select “Scan all device addresses (255 first, etc) since controllers connected with the CPI clip will be found at address 255 regardless of the address configured in the controller. Select “Connect via CPI clip or IR cable” and press OK After the clip is connected to the controller, plug the USB connector into your computer. The connector can be inserted independently of the device being fitted into its sleeve or not. Line up the pins and it should snap into place. The clip has a 5 pin connector that plugs into a socket on side of the controller. The first step will be connecting to the controller.
EUROTHERM ITOOLS NOT FINDING DEVICE DRIVERS
The Manual has full instructions for installing the drivers as well. Our site also provides the USB Clip manual, as well as a link to download the drivers.
EUROTHERM ITOOLS NOT FINDING DEVICE SOFTWARE
You can download the iTools Software package from either the Eurotherm website, or our website.
EUROTHERM ITOOLS NOT FINDING DEVICE DRIVER
You can clone 2000 series controllers if you have a communications module, or if you have a Eurotherm configuration station.īefore moving forward, you should have already installed the iTools Software package, as well as the appropriate driver for the USB Clip. The USB clip is compatible with 3000 series temperature controllers, as well the nanodac and mini8. By “clone” I am referring to saving the configuration information from a controller into a “clone file”, which can then be loaded into another controller.įor this demonstration we are going to use a 3216 with the eurotherm usb clip. This video tutorial will show how you can easily clone eurotherm temperature controllers.
0 kommentar(er)
